XIM Community

Back 4 Blood config and in game settings pre official ST  (Read 1211 times)

Offline Lyrayite

  • Member
  • *
  • Posts: 3
    • View Profile
  • PSN ID: CaptainAlexGREEN
500hz Global
3200 Mouse Dpi 1000hz
PubG
Hip 20.50 Aim 15 Both Default
Nothing else in config Game settings
Horizontal 100
Vertical 100
Deadzones 0.2
Aim Assist Strength(your preferences) 0-30 Recommended
Low zoom 0.4
High zoom 0.2
Ads snapping on
« Last Edit: 03:52 AM - 10/15/21 by Od1n »

Offline ioop16

  • Member
  • *
  • Posts: 108
    • View Profile
on XSS ?

Offline Lyrayite

  • Member
  • *
  • Posts: 3
    • View Profile
  • PSN ID: CaptainAlexGREEN
on XSS ?

I play on PS4/PS5 not sure if thereís a difference with XSS, try it out!

Offline Last Light

  • Member
  • *
  • Posts: 6
    • View Profile
Re: Back 4 Blood config and in game settings pre official ST
« Reply #3 on: 07:33 PM - 10/16/21 »
Thanks for sharing this, it was a really good starting point, but I had some minor tweaks.
My settings:
250Hz in Xim app
12000 dpi with 250Hz mouse

PubG ST
Hip: 15, Sync: OFF, Custom ballistic curve for precise aim AND fast 180 turns when zombies are behind you. Pasted the curve at the bottom.
ADS: 3.5, Sync: OFF

In-game settings:
Horizontal and Vert Sens: 100
Deadzones I had to decrease to 0.1 since 0.2 and above felt sticky trying to snipe
Aim-assist: ON, value of 30
ADS Low Zoom Multiplier: 0.4
ADS High Zoom Multiplier: 0.2
ADS Target snapping: OFF, this one was the biggest pain for me! Highly recommend you keep this off since ADS speeds are so slow in this game on non-upgraded gun...hurts more than helps!


>>> XIM APEX [Translate Ballistics] START COPY >>>
X5BC:AAAAXQC6ARcBdQHSAi8CjALpA0YDowQBBF4EuwUYBXUF0gYvBo0G6gdHh6QJmwuSDYgPfxF2E20VYxdaGVEbSB0+HzUhLCMjJRmnECcQJxAnECcQJxAnECcQJxAnECcQJxAnECcQ:X5BC
<<< XIM APEX END COPY <<<

Offline Lyrayite

  • Member
  • *
  • Posts: 3
    • View Profile
  • PSN ID: CaptainAlexGREEN
Re: Back 4 Blood config and in game settings pre official ST
« Reply #4 on: 03:48 PM - 10/18/21 »
Hey glad you tried them out, Iím trying your configuration but I just had one question?
Do I add the ballistic curve to the ADS as well?