XIM Community

Connecting PS4 and Xbox One controllers to one Xim4?  (Read 303 times)

Offline MohakMore

  • Member
  • *
  • Posts: 2
    • View Profile
Hi,

I was trying to connect both consoles to my Xim4 (not at the same time of course) and I tried going the usb hub and a usb splitter. Let me explain my setup and perhaps someone can guide me to fixing this issue or getting better hardware that will work for the scenario I'm trying to achieve.So the usb hub 2 inputs are plugged into the ps4 and xbox one https://19216801.onl/ https://routerlogin.uno/ https://192168ll.link/

Then I plugged the cable from my xim4 C port into the the output of the usb hub

Then with the Y usb splitter, I plugged each of those to the ps4 and xbox console controllers.

So when I tested it, it doesn't work quite right.  What I mean by that, the xim4 doesn't connect to either of the controllers.  But when I unplugged one of the controllers, it detected it just fine. So it seems that I can't have both controllers connected to that 3 dot port of the xim4. I was thinking perhaps if I found a usb splitter that had a toggle switch between the two controllers, would that work?

Is this setup to complex and can anyone recommend perhaps a better way of sharing the xim4 with both consoles.  I don't want to unplug each controller and reconnect it everytime.

Thanks,
« Last Edit: 12:53 AM - 07/06/20 by MohakMore »

Offline OBsIV

  • Administrator
  • MVP
  • *
  • Posts: 38290
  • It's obsessive.
    • View Profile
    • OBsIV's Blog
Re: Connecting PS4 and Xbox One controllers to one Xim4?
« Reply #1 on: 10:41 AM - 07/05/20 »
To clarify, you are looking to use 2 USB splitters? One to share your XIM4 between consoles, and one to choose which controller to use?
Get the most out of your XIM APEX, read the XIM APEX Support FAQ.


Admin