XIM Community

[ACTIVE] Ps4 mouse aim sensitivity bug  (Read 348 times)

Offline Fahad.m.a

  • Member
  • *
  • Posts: 24
    • View Profile
[ACTIVE] Ps4 mouse aim sensitivity bug
« on: 12:01 PM - 04/01/20 »
Hello .. im having an issue with the mouse aim sensitivity in the apex manager, the sensitivity i play with is no longer feel the same, it feels much faster now than it used to be. I checked all my sittings on the apex manager and in game sittings, i even bought a new g703 hero gaming mouse to see if this would solve the problem but it did not unfortunately

These are the sittings i use over a year and never changed them :
Polling rate in mouse and manager : 1000 hz
Mouse dpi : 16000
Mouse aim sensitivity 2.80
Sync : common
Y/X ratio : 1.02
Simulate analog behavior : off

Please help me because my aim is no longer as good as before 
« Last Edit: 04:38 PM - 04/01/20 by mist4fun »

Offline mist4fun

  • Global Moderator
  • MVP
  • *
  • Posts: 58122
    • View Profile
Re: Ps4 mouse aim sensitivity bug
« Reply #1 on: 04:38 PM - 04/01/20 »
Welcome to the community. Things that can affect sensitivity are DPI, Hip and ADS sensitivity, in-game sensitivity, Synchronize, the ballistics curve, YX Ratio, and APEX's response rate. I'd check each of these settings. If you recently changed APEX's response rate the change will take effect the next time APEX is reconnected. Some mice have profile buttons too, if your mouse has a profile button it may have switched to another DPI without using the DPI buttons.
Have a problem with your XIM APEX? Find a solution in the XIM APEX Support FAQ
XIM APEX Quick Start Guide   |   XIM Instructional Videos

Offline Fahad.m.a

  • Member
  • *
  • Posts: 24
    • View Profile
Re: [ACTIVE] Ps4 mouse aim sensitivity bug
« Reply #2 on: 12:21 AM - 04/02/20 »
Hello mist4fun

My mouse has on board memory, i disabled the dpi button on the mouse + I enabled one profile only on the mouse and set my dpi to 16000 , for hip i use hip translator and never played with ads because i only play overwatch with the xim apex , my in-game sensitivity is set to maximum 100 for horizontal and vertical , i use common for synchronize and a linear ballistics curve , 1.02 for YX ratio and a 1000 hz for apex's response rate

I only play overwatch with the apex so i just have one config for most of the characters i play with in this game and still suffering !!

Offline TurboMan

  • MVP
  • *
  • Posts: 512
    • View Profile
Re: [ACTIVE] Ps4 mouse aim sensitivity bug
« Reply #3 on: 06:42 AM - 04/02/20 »
Have you re-measured your 360/cm distance to see if it's actually changed, or if it just feels like it's changed?

Offline Fahad.m.a

  • Member
  • *
  • Posts: 24
    • View Profile
Re: [ACTIVE] Ps4 mouse aim sensitivity bug
« Reply #4 on: 10:37 AM - 04/02/20 »
Hi ZOMBIES

Yes i re-measured my 360/cm and i didnt see that im having the same turnspeed i play with like before. i cant even control my aim because its too fast. I tried to lower my mouse aim sensitivity a little bit but its still to fast

Offline mist4fun

  • Global Moderator
  • MVP
  • *
  • Posts: 58122
    • View Profile
Re: [ACTIVE] Ps4 mouse aim sensitivity bug
« Reply #5 on: 04:33 PM - 04/02/20 »
Sorry, I don't have other suggestions aside from lowering your XIM sensitivity in decimals, lowering mouse DPI, or choosing a different synchronize setting.
Have a problem with your XIM APEX? Find a solution in the XIM APEX Support FAQ
XIM APEX Quick Start Guide   |   XIM Instructional Videos

Offline Fahad.m.a

  • Member
  • *
  • Posts: 24
    • View Profile
Re: [ACTIVE] Ps4 mouse aim sensitivity bug
« Reply #6 on: 03:47 AM - 04/03/20 »
Helloo mist4fun

I have tested something new today. Usually i play with a config of overwatch called (Exponential) so i tried today to play with a different config of overwatch called (Linear) and my aim speed just got much better with the linear confg. I believe there is a problem with the exponential ramp config.

I had to buy a new xim apex, gaming mouse and mouse pad because I thought the problem is coming from one of them but then nothing has changed with the speed of the mouse aim sensitivity. It still too fast and unplayable

In general i still prefer my old aim speed with the exponential but for now ill stick with the linear because itís better than exponential. I really hope this issue can be fixed in the near future

Many thanks

Offline TurboMan

  • MVP
  • *
  • Posts: 512
    • View Profile
Re: [ACTIVE] Ps4 mouse aim sensitivity bug
« Reply #7 on: 07:29 AM - 04/07/20 »
As said above then it's hard to tell what actually went wrong, just re-adjust it to your previous 360/cm and you should be good hopefully.

Offline Fahad.m.a

  • Member
  • *
  • Posts: 24
    • View Profile
Re: [ACTIVE] Ps4 mouse aim sensitivity bug
« Reply #8 on: 03:51 PM - 04/14/20 »
Believe me bro I tried to adjust my 360/m to the one I usually play with but when ever i move the mouse on the mousepad the crosshair move so fast. I cant understand whatís exactly the problem even after trying to solve this issue with testing it on a new xim apex but its still hard for me to tell whats really going on with the aim sensitivity.. Ive been an apex user for so long, playing with the same sittings that I feel comfortable with over a year and overwatch is the only game i play with the apex, im pretty sure that there is an issue with the aim sensitivity