XIM Community

Very small problem with Razer Viper Ultimate and Razer Basilisk Ultimate  (Read 232 times)

Offline JuanDeage

  • Member
  • *
  • Posts: 143
    • View Profile
To the devs:

I have been using the Razer Viper Ultimate and the Razer Basilisk Ultimate with the XIM 4 and XIM Apex. On both when I first plug it in the mouse never registers. I believe this is because when plugging both Razer mice into the PC it resets all USB devices and then brings up the Synapse installer. Then you click cancel install. Well on the XIM it is as if it is doing this so I have to unplug and replug every single time I turn on the XIM 4 or XIM Apex and then the mouse will work fine after that. Is there anyway you could check to see razer mouse and then initialize once and then again to bypass this? Or would this be basically impossible? Also, is there anyway to hack out that stupid synapse installer in the dongle?

The mice works amazingly when it's fully initialized and is definitely recommended, but this issue is so annoying.