XIM Community

copy and paste configs help please  (Read 309 times)

Offline spookycheese500

  • Member
  • *
  • Posts: 3
    • View Profile
  • PSN ID: tommy2cute-
copy and paste configs help please
« on: 05:03 PM - 01/20/19 »
I can't figure out of the life of me how to copy and paste a config into the xim apex without getting an error!!! I have copied everything from inside the arrows to outside the arrows and nothing is working just get error

using xim manger on IOS

please help

Offline mist4fun

  • Global Moderator
  • MVP
  • *
  • Posts: 51599
    • View Profile
Re: copy and paste configs help please
« Reply #1 on: 05:47 PM - 01/20/19 »
Welcome to the community. A good place to start is to verify you're pasting the code in the correct location. Full config code copy and paste buttons can be found in the Identity section of the config. Ballistics Curve code copy and paste buttons can be found in the Ballistics Editor in the Aim section of the config. Be sure you're pasting the code in the correct location.

The code you're using may use a different code format from another build as well. If this is the case you would need to talk with the author to to find out which firmware and Manager version they used when sharing the code and then use that version.
Have a problem with your XIM APEX? Find a solution in the XIM APEX Support FAQ
XIM APEX Quick Start Guide   |   XIM Instructional Videos