OVERWATCH Linear Fix

[Supernatural X]

I'd say that the curve is better than the boost to be honest. Although when i'm in scope as widow, there if I move my mouse a very minute amount the game doesn't react. Probably a quarter inch approximately, so long distance micro movements are essentially non existent for me. Anyone have a fix for this??

Are you using an ADS config on the XIM? Did you apply the curve to both your HIP and ADS pages?

A Widow player earlier was having a similar issue and turns out they hadn't applied the curve to their ADS page.

That was me with the issue earlier. So yes I do have the curve applied to both Hip and ADS but it is still an issue when doing minute movements.

raise your boost/curve a bit. I had that same issue with the 8 curve and had to use 8,5 instead.

You think I should raise the curve just for my ADS page and not my Hip because the issue only occurs when in ADS?

[goaty]

I'd say that the curve is better than the boost to be honest. Although when i'm in scope as widow, there if I move my mouse a very minute amount the game doesn't react. Probably a quarter inch approximately, so long distance micro movements are essentially non existent for me. Anyone have a fix for this??

Are you using an ADS config on the XIM? Did you apply the curve to both your HIP and ADS pages?

A Widow player earlier was having a similar issue and turns out they hadn't applied the curve to their ADS page.

That was me with the issue earlier. So yes I do have the curve applied to both Hip and ADS but it is still an issue when doing minute movements.

raise your boost/curve a bit. I had that same issue with the 8 curve and had to use 8,5 instead.

You think I should raise the curve just for my ADS page and not my Hip because the issue only occurs when in ADS?

I did it for both. So both behave the same

[neat]

After using the Linear set up for a week solid, I have gone back to the Expo ST instead.. feels more fluent for me, closer feeling to PC than Linear..

Expo + 0 Aim Assist Window is brilliant compared to this set up.

Seconded.

[tsabyan]

So I'm trying to switch to this new linear mode. I'm using the razer death adder chroma at 10k dpi and I'm having trouble getting the boost mode right with no curve. I'm confused with what I'm looking for. It says to lower it until it feels smooth right before it cuts out. Can anybody explain exactly what I'm looking for here? Nobody else seems to use my mouse or setup so it's hard to just know what boost to set it too.

Asus ROG 144hz
Razer Death Adder 10k DPI
Razer Blackwidow Chroma
Xbox One

[Supernatural X]

So I'm trying to switch to this new linear mode. I'm using the razer death adder chroma at 10k dpi and I'm having trouble getting the boost mode right with no curve. I'm confused with what I'm looking for. It says to lower it until it feels smooth right before it cuts out. Can anybody explain exactly what I'm looking for here? Nobody else seems to use my mouse or setup so it's hard to just know what boost to set it too.

Asus ROG 144hz
Razer Death Adder 10k DPI
Razer Blackwidow Chroma
Xbox One

Get your mouse and move it very very slowly and see whether your crosshair moves on screen. If it doesn't lower your boost. Start at 5000 on Xbox One, just play around and make sure there is always movement when moving your mouse, try this in Widowmaker scope too might have to be different for in scope vs out of scope.

[Darryl]

Yeah, once you've set up the Console Controller Crossover profile and set Overwatch to Linear Ramp, you should notice right off the bat that it takes a LOT of mouse movement to turn or look around. The smaller mouse movements are being cut off and not recognized by Overwatch. As you raise the boost (or curve), you will find less and less mouse input necessary to start turning. Using the slowest mouse movement you can, you want to increase your boost until that slow movement is just being reflected on screen.

I have found that once I get this dialed in, I can even raise my sensitivity past where I used to have, which gives me far better turn speed/180's, because the tiny movements I make are translating properly rather than becoming overly fast accelerated swings with Exponential.

[Brust Free]

So MAJOR thanks to Gunit2004 and humanfemale for helping crack this mystery.
To keep it short we've all noticed that the Linear ramp on Overwatch doesn't kick in right away. Obviously the deadzone is broken, they set it too far away from 0. Luckily our friends here figured out that you can use the Xim to makeup that deadzone and then you have an amazing setting!

1) Copy your buttons from your current profile
2) Create a new CONSOLE CROSSOVER STnot overwatch Profile
3) Paste your buttons
4) Load up a practice skirmish; Linear Ramp; 0 Aim Smoothing; 100% Ingame Sens

CURVE MODE:
-Now start at the lowest part of your curve. Start kicking it up until you can SMOOTHLY move your mouse at a very slow speed (it will start choppy but as you move that number up you'll notice it'll smooth out and speed up, for me that was 12, for humanfemale it was 8 ) it seems to depend on your console, and mouse
-Now add as much to the top of the curve as you did to the bottom.You're trying to maintain that 45 degree slope.
-Now you can mess was sensitivity. No need for a boost. I have Steady Aim on but.... oh and 1.5 Y/X

UPDATED: BOOST MODE: (recommended) (SA3)
-No Curve, Put your boost to 5000 and then start slowly lowering the numbers by 5 until the micro-movements are smooth right before they cut out

EXTRA: Widow/Ana Zoom 41%, Aim Assist Window 5, Aim Assist 20

I didn't paste my curve in here because I think you should try to figured out your own. There really is no curve it's just adjusting the straight line for the deadzone. Too bad you can't just raise the whole curve line with one slider though this would literally be the ONLY application for that.

XBOX: (STARTS at +12 - May need .5 adjustment to taste/equipment)

>>> XIM4 [Mouse Ballistics] START PASTE >>>
X4MB:AAAAGgA0AC4AMAAwAC4AMgAwADEANgAwADQAMAA1GCIsNkBKVF5ocnyGkJqkrrjCyMjI:X4MB
<<< XIM4 END PASTE <<<

PS4: (STARTS at +8.5 - May need .5 adjustment to taste/equipment)

>>> XIM4 [Mouse Ballistics] START PASTE >>>
X4MB:AAAAGgA0AC4AMAAwAC4AMgAwADEANgAwADQAMAA1ERslLzlDTVdha3V/iZOdp7G7xcjI:X4MB
<<< XIM4 END PASTE <<<


Enjoy and Report Back

Hi
What do you mean by " CONSOLE CROSSOVER ST not overwatch profile " exactly ?
Thanks

[Supernatural X]

The Console Crossover ST is a different ST, when making a new profile just look at the top of the list, you'll find it, Overwatch ST doesn't work with Linear so we have to use the Console Crossover one.

[Lineater]

So does the boost version requires SA3 firmware?  If so, is that with SA on or off?

I tried to test boost instead of curve, and my mouse wasn't responding to small movements all the way up to 6000 boost.  I think I might have the SA5 build installed.

[gunit2004]

So does the boost version requires SA3 firmware?  If so, is that with SA on or off?

I tried to test boost instead of curve, and my mouse wasn't responding to small movements all the way up to 6000 boost.  I think I might have the SA5 build installed.

Boost version requires a firmware that doesn't replace the boost box with Steady Aim values. Since many of the SA firmwares replace the boost box with a steady aim value instead, you cannot use them with the boost method.

The only SA firmwares that do not take over the boost box are SA02, SA03 and SA04. Those are safe to use, or just use a regular firmware. IMO, Steady Aim firmwares are not even needed anymore with Overwatch because you already have so much flexibility with aim assist options (strength, window, etc). So using a regular firmware is just fine.

[A Big Ol Bully]

Linear Boost Users:
So I was messing around and I decided to apply an old COD curve to my boost/linear/CC-ST.
it allowed me to lower my sens for more precision but I can turn with less wrist movement. I've also tried to hit the limit to prevent flashing. This is probably only for Xbox but try to adjust the limit for PS4. It's going away from linear just a bit but until they raise the turn speed limit (which will never happen) I personally decided I'll deal with some float at faster speeds to turn better.
Try it out, love it/hate it
-also you'll need to lower your sens quite a bit but I noticed that the new map has some GREAT tracking dots all over the walls. It'll be my goto for my daily tracking exercises.

HIP:
>>> XIM4 [Mouse Ballistics] START PASTE >>>
X4MB:AAAAGgA0AC4AMAAwAC4AMgAwADEANgAwADQAMAA1ABkyS2RxeoCGjZOZn5+fn5+fn5+f:X4MB
<<< XIM4 END PASTE <<<


ADS:
>>> XIM4 [Mouse Ballistics] START PASTE >>>
X4MB:AAAAGgA0AC4AMAAwAC4AMgAwADEANgAwADQAMAA1AAoTHScxO0VPWXCHnp6enp+fn5+f:X4MB
<<< XIM4 END PASTE <<<

[Supernatural X]

Linear Boost Users:
So I was messing around and I decided to apply an old COD curve to my boost/linear/CC-ST.
it allowed me to lower my sens for more precision but I can turn with less wrist movement. I've also tried to hit the limit to prevent flashing. This is probably only for Xbox but try to adjust the limit for PS4. It's going away from linear just a bit but until they raise the turn speed limit (which will never happen) I personally decided I'll deal with some float at faster speeds to turn better.
Try it out, love it/hate it
-also you'll need to lower your sens quite a bit but I noticed that the new map has some GREAT tracking dots all over the walls. It'll be my goto for my daily tracking exercises.

HIP:
>>> XIM4 [Mouse Ballistics] START PASTE >>>
X4MB:AAAAGgA0AC4AMAAwAC4AMgAwADEANgAwADQAMAA1ABkyS2RxeoCGjZOZn5+fn5+fn5+f:X4MB
<<< XIM4 END PASTE <<<


ADS:
>>> XIM4 [Mouse Ballistics] START PASTE >>>
X4MB:AAAAGgA0AC4AMAAwAC4AMgAwADEANgAwADQAMAA1AAoTHScxO0VPWXCHnp6enp+fn5+f:X4MB
<<< XIM4 END PASTE <<<

Interesting settings will try it out ASAP, you're using the OW ST right? (I can't see the pictures because I'm at school) Do you think exponential feels better for you because your a high sens player?

[A Big Ol Bully]

Linear Boost Users:
So I was messing around and I decided to apply an old COD curve to my boost/linear/CC-ST.
it allowed me to lower my sens for more precision but I can turn with less wrist movement. I've also tried to hit the limit to prevent flashing. This is probably only for Xbox but try to adjust the limit for PS4. It's going away from linear just a bit but until they raise the turn speed limit (which will never happen) I personally decided I'll deal with some float at faster speeds to turn better.
Try it out, love it/hate it
-also you'll need to lower your sens quite a bit but I noticed that the new map has some GREAT tracking dots all over the walls. It'll be my goto for my daily tracking exercises.

HIP:
>>> XIM4 [Mouse Ballistics] START PASTE >>>
X4MB:AAAAGgA0AC4AMAAwAC4AMgAwADEANgAwADQAMAA1ABkyS2RxeoCGjZOZn5+fn5+fn5+f:X4MB
<<< XIM4 END PASTE <<<


ADS:
>>> XIM4 [Mouse Ballistics] START PASTE >>>
X4MB:AAAAGgA0AC4AMAAwAC4AMgAwADEANgAwADQAMAA1AAoTHScxO0VPWXCHnp6enp+fn5+f:X4MB
<<< XIM4 END PASTE <<<

Interesting settings will try it out ASAP, you're using the OW ST right? (I can't see the pictures because I'm at school) Do you think exponential feels better for you because your a high sens player?

No console crossover ST, and expo doesn't feel better linear is Much better. Unfortunately the last update messed up all the Overbuff scores but I'm top 5% in accuracy on most hitscan and even top 1% with Widow McCree and Soldier 76

[Griffexxx]

@A Big Ol Bully : what do u like better boost or Curve for linear, and whats your SR i need to stop taking settings from people that are plat lol, im GM and i keep taking these crazy settings and get recked lol ( not trying to be rude btw to anyone)

also what AA Window do u play as well as dpi and sens

My Perf :
Mouse - Final Mouse Scream
Keyboard - Blackwidow ( New Edition )
Mousepad - Zowie GS-R

My Settings :
100 AA Strength
15-22 AA window ( always changing )
AS - 0
Linear Ramp : curve starting 8.0 / and boost 3160
Expo Ramp : @#$% lol
- 800 Dpi
- 132 Boost Sens
- 132 Curve Sens
Firmware - https://i.gyazo.com/60b1044da2d10c396d29c4da7cc74e8e.png

[grandroyal]

@A Big Ol Bully : what do u like better boost or Curve for linear, and whats your SR i need to stop taking settings from people that are plat lol, im GM and i keep taking these crazy settings and get recked lol ( not trying to be rude btw to anyone)

also what AA Window do u play as well as dpi and sens

My Perf :
Mouse - Final Mouse Scream
Keyboard - Blackwidow ( New Edition )
Mousepad - Zowie GS-R

My Settings :
100 AA Strength
15-22 AA window ( always changing )
AS - 0
Linear Ramp : curve starting 8.0 / and boost 3160
Expo Ramp : @#$% lol
- 800 Dpi
- 132 Boost Sens
- 132 Curve Sens
Firmware - https://i.gyazo.com/60b1044da2d10c396d29c4da7cc74e8e.png

Guess we have gotten to the point where some posters rate advice and individual preferences by SR as if that means anything.