Browsing Category

# Survey Labs

36 posts

## Setting out simple circular curve- two theodolite method

Aim: To set out the simple curve by two theodolite method. Instruments Required: Two Theodolites and Ranging rods.…

## SETTING OUT SIMPLE CIRCULAR CURVE – RANKINE’S METHOD

Aim: To set out the simple curve by single theodolite method. Instruments required: Theodolite, Ranging rods, chain, arrows…

## To mark the centre line of foundation for the given building drawing.

Aim: To mark the centre line of foundation for the given building drawing. General Introduction: The process of…

## To determine the gradient of the line joining the given staff stations A and B and to find the RL of station B.

Aim: To determine the gradient of the line joining the given staff stations A and B and to…

## To determine the elevation of an inaccessible object (Tower)

Aim: To determine the elevation of an inaccessible object (Tower) Instruments required: Theodolite, Levelling Staff, Ranging rod, Tape…

## To run survey lines between various field objects by traversing and to find the area between given stations.

Aim: To run survey lines between various field objects by traversing and to find the area between given…

## Measurement of vertical angles with theodolite

Aim To determine the vertical angles of the given objects. Instruments required : Theodolite with tripod, Plumb Bob…

## Measurement of the horizontal angle by using reiteration method

Aim : To determine the included angle between the given stations by reiteration method Instruments required : Theodolite…

## Measurement of horizontal angle – repetition method

Aim: To determine the included angle between two object stations P and Q by using repetition method. Instruments…

## L-Section and cross section of the road (one full size drawing sheet each for L- section and cross section)

AIM: L-Section and cross section of the road (one full size drawing sheet each for L- section and…

## Fixing bench mark with respect to temporary bench mark with dumpy level by fly leveling and check leveling.

AIM : Fixing bench mark with respect to temporary bench mark with dumpy level by fly leveling and…

## Determination of elevation of various points with dumpy level by collimation plane method and rise & fall method.

AIM: Determination of elevation of various points with dumpy level by collimation plane method and rise & fall…

## To plot the contours of an area by method of squares (or gridding).

Aim: To plot the contours of an area by method of squares (or gridding). Equipment and Accessories: Automatic…

## To conduct profile leveling for water supply or sanitary line and to draw the Longitudinal section (L.S) to determine depth of cutting and depth of filling

Aim: To conduct profile leveling for water supply or sanitary line and to draw the Longitudinal section (L.S)…

## To determine difference in elevation between two points using reciprocal leveling and to determine collimation Error

Aim: To determine difference in elevation between two points using reciprocal leveling and to determine collimation Error Instruments…

## To determine difference in elevation between two points using fly leveling and Fly back leveling

Aim: To determine difference in elevation between two points using fly leveling and Fly back leveling. Booking the…

## To find the elevation of different point shown on the ground with respect to given arbitrary bench mark.

Aim: To find the elevation of different point shown on the ground with respect to given arbitrary bench…

## To survey a small piece of land by closed traverse technique using plane table.

Aim: To survey a small piece of land by closed traverse technique using plane table. Equipment and Accessories:…

## To Locate the position on the plan, of the station occupied by the plane table by means of observations to three well defined points

Aim: To Locate the position on the plan, of the station occupied by the plane table by means…

## To Locate the position on the plan, of the station occupied by the plane table

Aim: To Locate the position on the plan, of the station occupied by the plane table by means…