Long story short, I have a device which is working perfectly and now my kid has decided to jump on board the ps4 W11cE bandwagon, so I've put him together a device aswell, I'm using 4151 mcp and I've followed the schematics to a T from page 8 of this thread, I'm ising pot version 7 because version 8 I started to have difficulties with , so I've flashed teensy and that was fine I've calibrated the modded controller and that worked out fine, I've then gone to joy.cpl to calibrate the controller and everything is good apart from the y/x axis it stays in the top left corner, I can pull it about to top left middle and bottom left but it does not get to top right, right right and bottom right, but once I release my finger from the stick it pings straight back to top left and stays there, also if I push the left stick down there's no input in joy.cpl every other button trigger and right stick works fine but not the left stick. I have rechecked the soldering and connections and all looks fine, is there a solution to my problem, is this a software issue with the uncomments or something simple I've missed.
