I decided to recalibrate my XIM2. On a whim I also ran the XIMDebugger stress test. In doing so I received the following error "Debugger FAILURE: Right Trigger". It is consistently failing on Iteration 7. To test if it was my computer or driver, I borrowed a friends XIM2, calibrated and ran the stress test. My friends XIM2 seemed to test fine. I have both calibrated and run the stress test on my XIM2 and every time it fails with the same error on Iteration 7.
Am I doing something wrong or do I need to send the XIM2 in for repair?
----- Error Start
>>> Iteration: 5
XIM : < >Y < >X <*>B < >A < >LS < >LB <*>RS < >RB < >BK < >ST <*>R < >L <
>D <*>U <-10752>RSX < 32448>RSY < 32634>LSX < 8201>LSY < 0>RT < 0>LT
Controller: < >Y < >X <*>B < >A < >LS < >LB <*>RS < >RB < >BK < >ST <*>R < >L <
>D <*>U <-10616>RSX < 32424>RSY < 32661>LSX < 8067>LSY < 0>RT < 0>LT
(MSD=0.415%)
>>> Iteration: 6
XIM : <*>Y < >X <*>B < >A <*>LS <*>LB <*>RS < >RB <*>BK < >ST <*>R < >L <
>D <*>U < 12524>RSX <-22994>RSY < 24097>LSX < 7516>LSY < 0>RT < 18650>LT
Controller: <*>Y < >X <*>B < >A <*>LS <*>LB <*>RS < >RB <*>BK < >ST <*>R < >L <
>D <*>U < 12567>RSX <-23046>RSY < 24029>LSX < 7399>LSY < 0>RT < 22912>LT
(MSD=0.357%)
>>> Iteration: 7
XIM : < >Y <*>X <*>B < >A < >LS <*>LB < >RS < >RB < >BK < >ST < >R <*>L <*
>D < >U < 1610>RSX < 29889>RSY < 24614>LSX <-11657>LSY < 9512>RT < 3753>LT
Controller: < >Y <*>X <*>B < >A < >LS <*>LB < >RS < >RB < >BK < >ST < >R <*>L <*
>D < >U < 1664>RSX < 29908>RSY < 24562>LSX <-11738>LSY < 0>RT < 0>LT
Debugger FAILURE: Right Trigger
Press ESC to exit ...
----- Error End
