--questions on xim edge--

[Scoobz]

Not sure if these been asked but from watching the video when you unplug from the xbox to the pc to get configs or ST's, do you have to unplug all the peripheral cables? or can you leave them plugged in when switching the micro cable from an to the pc?

Second question is about switchers. Im not sure if i missed it in the videos about the Edge but will we have to create switchers on the pc?

[Xog]

http://xim3.com/about/manuals

"Unplug all peripherals so the XIM Edge will enter PC Mode when it is plugged into your computer's USB port."

[Griffin]

I think I read OBsIV say that you really only have to unplug your controller from the device, although the guide says you must remove everything. May be remembering wrong.

Switchers were addressed in a thread earlier today: http://www.xim3.com/community/index.php?topic=21063.0

[Scoobz]

Ahh ok thanks Xog.

Yeah Griffin i hope its just the controller to unplug cause it would be not so much a pain to unplug them all but just a bit inconvenient in a way.. Thanks for the link as well!