XIM Community

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - venemous888

Pages: [1]
« on: 06:18 PM - 01/20/22 »
Does anyone have a good rust config with good aim. Mine is super slow and I canít get it right. I would be extremely grateful for anyone to share.

General Discussion / Rust console edition
« on: 10:33 AM - 05/17/21 »
Iím just wondering that as a brand new game, how long will it take for settings and a config option to come out? And if itís not out for a while, can I just use some other game option and use that as the config.

I was looking at a YouTube video on how to minimize recoil using the auxiliary part of the config (https://youtu.be/pTzoLp2lYJw), and I noticed how they were using The left click button to activate a motion on the right stick down. I donít know much about the XIM and itís code, but couldnít you make it so you can toggle a certain button pressing over and over again with a keypress that you could set up in the app? Iíd imagine it would be sort of like the anti-recoil trick in a way.

OK I finally figured it out. I grabbed every single USB Cable I could find in my house and test of them. I finally found one. I cannot give you the link for this cable, because I have no idea where it came from. However I suggest you go to Best Buy or Amazon or someplace and get a cable but be sure to make sure itís a data cable not a charging cable. This is the best solution I can offer. Best of luck to all.

Yes I have. When I plug it in the controller doesnít turn on, Iíve heard it is meant to. When I plug it in it does the color sequence then stays red. I have tried turning the controller on once it is plugged in, but then that controller controls it and not my mnk.

Welcome to the community. Did you try turning on the controller (pressing Guide) after everything starts up?
could you elaborate on that? Is the guide button the Xbox button?

I have updated to the latest software,  and have the Xbox series X. When I plug in my old Xbox one controller, it does not read it. It does not show up in the app as well as turn on. I have unplugged the XIM, plugged everything into it, then plug that into the Xbox and it still doesnít show up. I have tried three different cables, as well as tried plugging in my new Xbox series X controller and it still doesnít read it. When I plug it in the XIM is red.

Pages: [1]