XIM Community

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Proxyone

Pages: [1]
1
Beta / Re: XIM4 BETA [Firmware 20181012] (**LATEST**)
« on: 09:51 PM - 10/12/18 »
Working well on my end. 3 solo games, 1 squad game tried to move hecticly all the time spamming the keyboard change wep, strafing etc and didn't even once get kicked. Well done Obsiv and team, thank you very much.

2
XIM APEX Discussions / Re: Fortnite detecting my Xim Apex?
« on: 02:32 PM - 10/11/18 »
Is this happening to PS4 users too? If so, that's strange since there are already licensed mouse and keyboard adapters on that platform.

Yes my friend using horipad licensed for ps4 and got the same thing.

3
XIM APEX Discussions / Re: Fortnite detecting my Xim Apex?
« on: 02:16 PM - 10/11/18 »
it would be helpfull if someone could test

- cross controller config, do you get kicked using a xbox controller on playstation or vice versa?
- wooting one keyboard
- titan two or other mouse and keyboard adapters, are they affected too?

Ds4 and mouse using xim4 hub played 3 games no boot. And then keyboard and mouse on the next game via xim4 hub, 2 mins later bam booted. By this im sure the movement in keyboard or w,a,s,d are the one detected by the server.

4
XIM APEX Discussions / Re: Fortnite detecting my Xim Apex?
« on: 01:36 PM - 10/11/18 »
I tried stick and mouse for 2 games and no kick. Keyboard mouse next game bam got kicked again. I think movement in w,a,s,d are the ones detected from server side. Because no client patch today?

5
Game Support / Re: OVERWATCH Linear Fix
« on: 09:53 AM - 06/29/17 »
So after lurking here for a bit, I've finally decided to post. The quest for the perfect settings continues, and has become quite frustrating.
My current setup:
Logitech G403 wired at 12k dpi/1000hz (was using default 3200 dpi with 60 xim sens, but moved up to 12k at forum advice)
Logitech G13
Big cloth mouse mat.

So far I've been using:

Console Crossover ST w/Linear Ramp
100/100 sens in game
0 aim smoothing
100 aim assist
10 aaw
xim settings -
12 sens
1.5 x/y ratio
no curve
4250 boost

- This allows me to turn really fast and do a 180 without much mouse movement and feels good for genji, however its constantly hitting the turn speed limit and causing the xim to flash red. Its not good for precise aiming either.

Also used the above settings with Hoodlums #1 curve and only 750 boost to overcome the deadzone, and this is my current goto setting for hitscan, typically (not always) gets me 45-50% accuracy with soldier and gold kills and damage. However, tracking can be difficult at times when confronted with tracer and genji. Also, no matter how fast I turn with this setup, I never get the red flashing lights.

Tried Hoodlum's #2 curve as well and it wasnt great for me, couldn't turn. I realize these curves were made for ps4 and me being on Xbox, I need to raise the curve or add boost, and i'm hesitant to start modifying curves. I think I will try the curve posted on the first page of this thread, or spend more time on expo ramp with the Overwatch ST, as most of the high SR posters on this former seem to be using expo ramp w/Overwatch St and no curve or boost, proving that simple is better lol. I'l also probably go back down to 3200 DPI, as 12k seems jittery when tracing the outlines of objects, probably due to my mousepad.

So tonight I'll play with the curve Big Ol Bully posted on page 1 on Linear Ramp, as well as more time on the Overwatch Expo Ramp ST, and pick one and stick with it. Hoodlum's #1 feels good but definitely isn't perfect and behaves oddly at times.

Yea if you want precise aiming, try the curve. With boost it's kinda floaty even after fine tuning it.

6
I tried low sens but my arm and my fingers couldn't understand how to do micro aim (between 1-20ish degree) on low sens. I use claw grip and move the back of the mouse for my micro aim. Over 20ish degree aim, my front claw reflex will kick in and to do full 180 i need edge to edge on Qck+.
On 12k dpi my back claw can't memorize anything for micro aiming, its just inconsistent (overshoot, jitter, can't snap). Are you a palm grip user? Do you memorize your micro aim on your upper arm, no wrist movement allowed?

7
Using 226 sens (due to controller crossover st) on 1200 dpi and i still find it better than using 22.6 sens on 12k dpi in overwatch ranked master atm. But i hear that sens over 50 is bad when using xim, is that true?

8
Beta / Re: Need feedback for 20151222 RC
« on: 02:37 PM - 12/30/15 »
Thanks for your feedback. The rollover issue may be different depending on which keys you are pressing as well.

---

Do we have any wired Nav users using this build? If so are you experiencing nav disconnects that you didn't experience in previous builds?

Do you know which keys on the BWU keyboard usually cause the rollover? Or is it different for every BWU keyboard?
Sorry to ask this, but i need to recreate the issue to see if i really need to change the keyboard or not. Thank you.

9
Beta / Re: Need feedback for 20151222 RC
« on: 07:50 AM - 12/30/15 »
I'm using this firmware on PS4 with g502 and a razer blackwidow ultimate. I don't really know how was the poor rollover problem with this keyboard as i just purchased xim4 like 2 days ago, i did read the compatibility list and was prepared to buy a new keyboard so i installed this fw as soon as i open the box.
So yesterday i went to patrol, pressed like 6 numkeys and hold them and on the same time I went strafing to left front and i can still jump without stucking. But if i press 9 numkeys, jump would be stuck.
So i think the poor rollover problem for this keyboard is kinda fixed, i mean noone would press like 12-13 keys at the same time right? I am happy 👍

Pages: [1]