XIM Community

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - xxgmon3yxx

Pages: 1 [2] 3
16
Tutorials / Re: Tut: USB -> DualShock 4 adapter mod (WIP)
« on: 04:03 PM - 01/01/14 »
Also RX2/RY2 are the ones on the bottom when we stack them together|?

17
Tutorials / Re: Tut: USB -> DualShock 4 adapter mod (WIP)
« on: 03:14 PM - 01/01/14 »
Thanks man! last question 8,3k resistor connects from L2 to 3.3V? Can I just connect the resistor to pin 6 and 8.?

18
Tutorials / Re: Tut: USB -> DualShock 4 adapter mod (WIP)
« on: 01:02 PM - 01/01/14 »

When roads sees this, he will run away screaming like a little girl, yelling "T-T-T-THERE IS A MONSTER, R-R-RUN AWAYYYYYY".

Thanks a bunch man!! exactly what I needed.. Just to be clear the green ones are optional?

19
Tutorials / Re: Tut: USB -> DualShock 4 adapter mod (WIP)
« on: 02:14 PM - 12/29/13 »
I just need the complete picture ring circuit, because I'm stuck on where the gnd go and also the 3.3v oh @#$% it, if you have schematics of the whole lot of wiring I'll take them.

Just want to game with you guys, after seeing W11cE and Wurst game last night I feel left out.

+1

W11ce if you find the time this is important for the average electronoob.
+1

I'm almost done I think, im just stuck on the 2 middle MCP's, I might even be wrong  on some on my wiring so a complete schematic would be nice to double check.

20
Tutorials / Re: Tut: USB -> DualShock 4 adapter mod (WIP)
« on: 08:03 PM - 12/28/13 »
Im stuck on L2 and R2. DO they go from pcb to mcp4131 to host shield? Can anyone put up a complete schematic? showing all components wired together please?
Light blue connection goes from pcb to MCP. It does not connect to host shield, unless you mean those SPI connections that are connected together on all devices. I might do a complete schematic at some point.

Stuck again... l2 and r2 are connected together with wiper too? What about the  8,2k resistors? one is hooked to an orange 3.3v( Pin #8) and the other one to a yellow pin#6. but pin #6 is blue for L2 R2..

21
Tutorials / Re: Tut: USB -> DualShock 4 adapter mod (WIP)
« on: 09:56 AM - 12/26/13 »
Im stuck on L2 and R2. DO they go from pcb to mcp4131 to host shield? Can anyone put up a complete schematic? showing all components wired together please?
Light blue connection goes from pcb to MCP. It does not connect to host shield, unless you mean those SPI connections that are connected together on all devices. I might do a complete schematic at some point.

Great man! I would appreciate it if you do.!

Thanks!

22
Tutorials / Re: Tut: USB -> DualShock 4 adapter mod (WIP)
« on: 05:13 PM - 12/21/13 »
Im stuck on L2 and R2. DO they go from pcb to mcp4131 to host shield? Can anyone put up a complete schematic? showing all components wired together please?

23
Tutorials / Re: Tut: USB -> DualShock 4 adapter mod (WIP)
« on: 12:39 AM - 12/21/13 »
How do I flash the software?

24
Tutorials / Re: Tut: USB -> DualShock 4 adapter mod (WIP)
« on: 06:00 PM - 12/17/13 »
Can I use the XIM 1 with this?

25
General Discussion / Re: PS4 plan B
« on: 12:40 PM - 12/14/13 »
W11cE are just 2 of the MCP4131's solder onto the board? What about the other 6?

Thanks in advance!

26
General Discussion / Re: PS4 plan B
« on: 10:34 PM - 12/12/13 »
LOL. I was actually going to suggest that just rip those out, but thought that would be just too harsh. Those are paint it the @#$% to desolder. You basically melt the other side and on the other side the solder is still solid. Those will get out easily if you get all solder on all 3 points melt at the same time. But that cant be done easily.

Got all the parts ordered! Could you start a new thread when u post the tutorial? Thanks!

27
General Discussion / Re: Carbon project for PS4
« on: 04:45 PM - 12/11/13 »
This one kinda looks a bit more complicated than Plan B. I wonder which one is going to perform better.

28
General Discussion / Re: Carbon project for PS4
« on: 06:06 PM - 12/09/13 »
http://www.softfactory.com.br/index.php/10-carbon-intro

He will be releasing a tutorial soon!

29
General Discussion / Re: PS4 plan B
« on: 05:35 PM - 12/07/13 »
 W11cE are you going to sell this thing or not? if ur not into making money then share the blueprint please.

What if we took our xim ones and modified them in a similar manner? would that work?

30
General Discussion / Re: PS4 plan B
« on: 09:33 PM - 12/05/13 »
Is just a matter of time before someone releases a tutorial on how to do this. A guy in Brazil got it working as well. "Thinking" about releasing a tutorial is just stalling, who cares if is a step backwards man but this community is hurting for a solution if you want to sell the tutorial I can pay for it if thats what you are looking for, but do so in a timely manner man before someone else starts banking on this solution before u do(Marketing 101) take the money and run dude thats all im saying.

If u want to make deals via email or private msg let me know man I got the $$$ ready to go(cash, certified check, money order) let me know before is too late.
^^^^
Same here am willing to pay lets do this get the ball rolling.  I need a temp solution for now and will pay for it, what do we need to do to get this done?

Im telling you, people want it plus who does not like money? Money = Power! welcome to 2013!

Pages: 1 [2] 3
Admin