XIM Community

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Ascendedclone

Pages: [1]
1
Title.

Anyone have this issue? Any suggestions?

2
Game Support / Re: Planned Support List
« on: 09:08 AM - 03/14/19 »
Will black desert online get a ST?

3
General Discussion / Re: Xim 4vs xim apex
« on: 07:57 AM - 03/04/19 »
Key differences -

XIM Apex supports 125Hz, 250Hz, 500Hz and 1000Hz polling. XIM4 supports 125Hz only.
XIM Apex supports controller chat. XIM4 doesn't.
XIM Apex offers more advanced features to manage things like Aim Assist than XIM4.
XIM Apex is cheaper than XIM4.

If xim4 only supports 125hz then would it be best to use 125hz on the mouse regardless of what the mouse is capable of? 

4
mass effect andromeda worked very good

Ooo i didnt think to use that for some reason. I will give it a try tonight

5
Im using destiny 2. 3200 dpi.

All ingame sense maxed out.

Hip aim is a little bit choppy but as i have had limited time to mess around i wasnt to fussed.

6
XIM 4 Discussions / Re: Apex Legends Official ST Thoughts
« on: 04:02 PM - 02/13/19 »
Try using High Velocity in-game with 7- 7 or 7 - 6 in-game ( I prefer the latter as the aim assist bubble seems a bit too strong with 6) . You won't hit the turn cap and it'll be more natural to do 180 degree turns:

My set up :
4k DPI
1000 HZ
Sync; Common
HIP: 0.75
ADS: 1.00 (X/Y 1.05)

In-game : 7 - 7 with high velocity. All else default.
FOV : 96 if you care.

I will give this a whirl shortly...

I just cant get on with the official st and classic.

Titanfall settings on the other hand work great. But there has been many times where i get screwed over by aim assist. Cheers

7
@Alan

Is the xim4 balistic for ads or hip? Or both?

8
I tried the suggested settings but i get the extra movement on ads affter i stopped moving the mouse.

I have been testing and now im using 26/26 on right stick. It is very stiff but it sticks so hard to targets its unreal.

Im not sure if i like it but i dont have that after sway and people are dying easily.

I dont suppose there is any suggestioms on boosts or curves that may cutout the delay when using he games settings you posted?

No, if all in-game settings are correct performance should be smooth. Many of the advanced settings can negatively effect performance when used incorrectly. I recommend creating a new BFV config to ensure they are all default.

This worked thankyou... l

9
I tried the suggested settings but i get the extra movement on ads affter i stopped moving the mouse.

I have been testing and now im using 26/26 on right stick. It is very stiff but it sticks so hard to targets its unreal.

Im not sure if i like it but i dont have that after sway and people are dying easily.

I dont suppose there is any suggestioms on boosts or curves that may cutout the delay when using he games settings you posted?

10
I couldnt find a introduction section and to keep on topic i shall make this short.

I have been using xim4 for about 9 months now. I usually get all the info from improvig and settings ect from here and reddit. There has been a few times i wish i would just register and now has come the time.

I was using Battlefront 2 ST at first with dead zone at 22%

This seems abit off now with the BFV setup. Any new suggestions?

Im about to play now so i will have a fiddle around amd keep checking back here.

Thanks admins and all others who provide the testing and infomation. You are all doing gods work!


Pages: [1]