XIM Community

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Coponz

Pages: [1] 2
1
XIM APEX Discussions / Different mouses cause input lag
« on: 09:05 PM - 03/20/18 »
Hi,

Is it known that different brands of mouses can cause input lag ?

I have a Zowie mouse and a Logitech Pro mouse both pretty good.

But was wondering if the actual mouse can cause input lag.

Thanks.

2
Game Support / Re: PUBG Official ST discussion thread!
« on: 06:27 PM - 03/18/18 »
Hi,

Is anyone here using Zowie at 3200, 1000hz, new Beta, and Cloth Pad.

Keen to know what settings your HIP and ADS is.

I average about 5 kills per game on solo.

Cheers. :)

3
Game Support / Re: PUBG Official ST discussion thread!
« on: 01:51 PM - 03/14/18 »
Hi,

I have a question.

Is it possible to play the new beta with this curve.

I had to do a factory reset to set back to the original firmware to load in the curve on my PC.

Could not do from IOS app.

Cheers! :)

4
Game Support / Re: PUBG Official ST discussion thread!
« on: 07:34 PM - 03/13/18 »
Here you go, full setup on Apex. Like I said though... WIP.
1000hz

Code: [Select]
>>> XIM APEX [PUBG] START COPY >>>
X5C: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:X5C
<<< XIM APEX END COPY <<<

In game settings.
Dz 20
AA 0
Everything 10

Hi RML,

What is your HIP and ADS sens at 4000 dpi ?

If know you use a hard pad so if i times your settings by 3x I can still play at 12,000 dpi.

Thank you.
 :)

5
Hardware Compatbility / Re: Death Addar Elite or G502
« on: 10:48 PM - 03/11/18 »


Hi Guys,

Understand this post probz be smashed before.

For apex though should I get Death Addar Elite or G502

Currently using zowie ec2 max dpi is only 3200 dpi.

Does Death Addar have problems with custom dpi e.g 6750. Seen post stating only goes up in blocks. Like the reduce weight compared to G502.

Let me know
Cheers




Neither. Get the Rival 600.


This mouse software does not know if your using hard or soft pad though ?

6
Game Support / Re: PUBG Official ST discussion thread!
« on: 04:17 AM - 03/09/18 »
Hi I just bought a G503 are most people using soft cloth pads ?

If my dpi is 4K do I need to crank it to 12k because my mouse pad is soft pad.

I'm assuming you mean a G502. I'm using a cloth pad and the general rule of thumb is - hard pad = speed / cloth pad = accuracy and precision

Its best, IMO, to crank it up all the way to 12k hz with 1000 polling rate. Apply 1000hz to your Xim apex app. Don't forget to use Smoothing, as needed, in case you experience jitterness

Do you smothing of 7 ?

7
Game Support / Re: PUBG Official ST discussion thread!
« on: 10:57 PM - 03/08/18 »
Hi I just bought a G503 are most people using soft cloth pads ?

If my dpi is 4K do I need to crank it to 12k because my mouse pad is soft pad.

8
Hardware Compatbility / Death Addar Elite or G502
« on: 05:25 PM - 03/08/18 »
Hi Guys,

Understand this post probz be smashed before.

For apex though should I get Death Addar Elite or G502

Currently using zowie ec2 max dpi is only 3200 dpi.

Does Death Addar have problems with custom dpi e.g 6750. Seen post stating only goes up in blocks. Like the reduce weight compared to G502.

Let me know
Cheers

9
Game Support / Re: PUBG Official ST discussion thread!
« on: 01:46 PM - 03/06/18 »
Hi,

Are people using the new Beta Fireware  ?

I have downloaded it. Apparently helps with the smoothing.

10
Game Support / Re: PUBG Official ST discussion thread!
« on: 03:28 PM - 03/04/18 »
Hi,

I am currently using 40 sensitivity as I use a 3200 dpi mouse (Zowie).

It is currently on 1000 polling. I get the Apex today in the mail.

Do I just need to set my sen to 320 ?

Cheers :)

11
Hardware Compatbility / Re: Xim Apex
« on: 04:30 PM - 03/01/18 »
Awesome,

Can play straight away then!

Cheers Guys

 :) :) :)

12
Hardware Compatbility / Xim Apex
« on: 08:43 PM - 02/28/18 »
Hi Guys,

I hope I not asking a question that has been stated.

However, do I need to download new firmware when the Apex get delivered ?

Thank you.

13
XIM APEX Discussions / Re: Not long now!?!
« on: 08:34 PM - 02/28/18 »
Paypal WORKS!!!!!!!!!!!!!!!!!!!

Got it !!!!!!!!!!!!!!!!

 :) :) :) :) :) :) :)

14
XIM APEX Discussions / Re: Not long now!?!
« on: 08:16 PM - 02/28/18 »
Hi Guys!

It been 1 hour 15 mins lol made it to purchase but then it freezed.

LOLOLOL

Still waiting....

 :) :) :) :) :)

15
XIM APEX Discussions / Re: Not long now!?!
« on: 07:03 PM - 02/28/18 »
Definitely not the 1ms response time I was looking for when I hit "Proceed to Checkout"

lol nice one!


Pages: [1] 2
Admin