XIM Community

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Zationysk

Pages: [1] 2 3 ... 6
1
XIM APEX Discussions / Re: Question about wait list.
« on: 09:15 PM - 01/11/18 »
Will you guys ship it to Brazil?

Because the last time i had to pay 3x the cost to order from a 3rd party when I got the xim 4. XD

2
Game Support / Re: Procuro por jogadores Xim4 Do brasil !
« on: 10:43 AM - 12/02/17 »
Eu ja fui GM duas vezes em temporadas anteriores mas parei de jogar. Talves eu volte durante os proximos eventos.

3
What do you guys put for the in-game settings "Stick Deadzone"?  I put this setting to 0%, should I have just left it at default?

21 is the default value that Mist recomend to use with the SWBF2 ST and that is what I have been using for everything.

4
I was using g502 + PS Nav but swith the Nav for keyboard. I also use turn assist on space bar.

My current Starships settings: 160 sen and this curve:

>>> XIM4 [Mouse Ballistics] START PASTE >>>
X4MB:AAAAGgA0AC4AMAAwAC4AMgAwADEANQAwADYAMAA2AAwgN1R1ncjIyMjIyMjIyMjIyMjI:X4MB
<<< XIM4 END PASTE <<<

5
What is the difference between the hip and the ads translator in the battlefront 2 ST?

Did u guys change the "Vehicle/Starfighter Response Curve"?

6
Hey guys. Let's share our settings for soldiers, vehicles and ships.

Mouse: G502 at 2k dpi.

Hip xim sen: 33, Hip translator
Ads xim sen: 20, Ads translator (still adjusting)

Aim Assist off: Off (I am curious if u guys are running it on or off. I feel better with it off but not sure yet).


Vehicles: Working on it. I will update later.


Starships settings: Turn assist on space bar, 160 sen and this curve:

>>> XIM4 [Mouse Ballistics] START PASTE >>>
X4MB:AAAAGgA0AC4AMAAwAC4AMgAwADEANQAwADYAMAA2AAwgN1R1ncjIyMjIyMjIyMjIyMjI:X4MB
<<< XIM4 END PASTE <<<


What is the difference between the hip and the ads translator in the battlefront 2 ST?

Did u guys change the "Vehicle/Starfighter Response Curve"?


7
I played overwatch a lot at 12 k dpi then switch to 2k and it felt more responsive with the same equivalent sensitivity, my avg accuracy per match also went up. So now I use 2k dpi with g502 in every game. I also read somewhere that it's because of the g502 that doesn't work as it should with higher dpi.

Test both and see what u like. There is definetly a diferense but idk exactly how to describe it.

8
Game Support / Re: Post your Overwatch Settings
« on: 03:55 PM - 06/22/17 »
I have found Tracer so much more usable since moving to Linear with the Console Crossover profile. I have turned my G502 down to 2k like suggested and was skeptical about it. It does seem improved to me as well though. I have my sensitivity up around 110 or so. 4875 or so on the boost (xbox). I can turn around much quicker than I used to be able to with exponential, and because the input is so much more precise and responsive than exponential, I can use tiny movements to move in small and precise ways. It's not -perfect-, but dare I say it is almost PC-like.
With curve or without it ? I mean do use Boost and Curve 8.5 at the same time ?

No test both and pick one ;P

9
Game Support / Re: Post your Overwatch Settings
« on: 09:31 PM - 06/21/17 »
I tried your config and I really loved it ! Thanks for sharing it my friend, really appreciated. It's really feels good to play with this new setting...
but there's one problem... turning speed is a little slow ... it's fine for Widowmaker / Soldier , but not the best for Tracer ... any suggestion?

Hey :D

Since them I change my settings a lot. I lowered my dpi all the way down to 2k and increase the sensitivity to 84 with the curve method. Then I tried the boost method and I use 3300 for hip with 90 sensitivity and 3350 for ads with 36.9 sensitivity.

But yea I didn't think that lower the dpi was going to do anything but it really feels more responsive to me. I think the g502 adds more input lag after 2k dpi or something all I know is that it feels better for me.

Now I am just struggling to figure out if I like better the boost method or curve at 8.5.

Both feel pretty good but diferent.

Now for tracer u can always just increase the sensitivity if u want to do 180s quicker.

I hope that helps. :D

10
Now that I am using 2k dpi I had to increase the xim sensitivity a lot as well but it feels better than before.

Do u guys know at what point increased xim sensitivity causes problems like interpolation? I read some ppl say it starts like 40/50 and others say that it's only past 100.

Which one is it?

11
Game Support / Re: Overwatch curve scale
« on: 03:54 PM - 06/11/17 »
Just increase the first step of the curve until u see smooth aim movement when u barely move the mouse then add +5 every step all the way to the top.

12
Game Support / Re: OVERWATCH Linear Fix
« on: 07:37 PM - 06/09/17 »
I haven't been watching this thread, but, I'm curious why anyone is using Linear given that the Overrwatch translator wasn't designed to work with it?

Humanfemale manage to make linear work using the CCC ST + a curve. And it is amazing!



13
I have the g502 and tested 2000, 3600, 4000. Converting the sensibility to be equivalent to what I had at 12000.

I can say that after playing at 2k dpi all other settings feel like trash to me.

Idk how to explain what makes it better. Maybe there is acceleration after 2k or maybe more Input lag idk... But I am happy I tested it.

So I think u guys should give 2k a go specially if u have g502. It feels much more responsive.



14
Game Support / Re: OVERWATCH Linear Fix
« on: 06:48 PM - 06/09/17 »
So after reading that post about 12000 dpi sucks on this forum. I decided to test it out just for the sake of it... I didn't think it was going to be better.

I have the g502 and tested 2000, 3600, 4000. Converting the sensitivity to be equivalent to what I had at 12000.

I can say that after playing at 2k dpi all other settings feel like trash to me.

Idk how to explain what makes it better. Maybe there is acceleration after 2k or maybe more Input lag idk... But I am happy I tested it.

So I think u guys should give 2k a go specially if u have g502. It feels more responsive, specially on linear.





15
Game Support / Re: Overwatch Settings
« on: 02:05 PM - 06/06/17 »
Check the other posts bro.

Here u can find my current settings.
http://community.xim.tech/index.php?topic=47049.msg615614#msg615614

Pages: [1] 2 3 ... 6
Admin