XIM Community

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - abs0lut

Pages: [1]
Configurations and Requests / Army of Two
« on: 06:45 PM - 09/07/08 »
Deadzone - 4400 (Square
YX Ratio = 1.5
Translation Exp. = .75
Sens Prim. = 1250
Sens. Sec = 2000
Diagonal Dampen = .25
Smoothness = 2

The reason my sensitivity is so low is because Army of Two actually accelerates the cursor when you turn far enough.  So if you want to make fast turns with this game, swing your mouse and hold it and the game will accelerate the mouse really fast to get you where you want.  Try it in game you will get a sense of what I mean.

Configurations and Requests / BF:BC config
« on: 03:08 PM - 09/07/08 »
Here is a little rough draft for the BF:BC guys out there.  I got my numbers from previous nick posts, a little experimentation and suggestions as well.  Keep in mind I don't really like the quick flick shots, I am more sim style controlled aiming.  But it is still pretty quick and will feel nice:

Deadzone: 11700 (Square)
YXRatio: 2
Translation Exponent: .33
Prim. Sens: 5400
Sec. Sens: 6400
Diag. Damp: .20
Smoothness: 0
Update Rate: 60

I am using a g5 laser at 800 dpi, 2k is waaay too quick for me and it actually gets a little choppy.  I am still tweaking to get rid of the chopiness so I can run at 2k dpi, it helps when you control tanks and other heavy ammunition.  In game sensitivity is all the way up and aim assist is on.

Check back later for more adjustments.

Topic, and if anyone knows the deadzone, lemme know, I am having problems using the deadzonefinder that came with the software.

XIM 2 Discussions / DIY Kit checklist
« on: 06:44 PM - 09/04/08 »
I just went shopping at radio shack for some tools to get my xim2 up and running when it arrives.  This is a post to just make sure I am starting on the right foot aka do I have the correct tools for the task.  I went to heald and did some soldering there maybe 3 years ago but I am somewhat out of the loop now.  Here is what I have.

15W Cordless Battery-powered Soldering iron


Insulated Wrapping Wire 30 gauge solid Conducter


Rosin-Core .022 diameter 62/36/2


Desoldering Bulb


Tell me what youi guys think.  I may have been off with the solder though?? ???

General Discussion / x360 on my monitor
« on: 06:21 PM - 06/08/08 »
I bought a Gateway 19"  lcd monitor not too long ago and just noticed that my 360 doesn't have the 1440 x 900 display that my monitor runs 720p with.  Anyone know the best setting on the 360 for this display?

General Discussion / Need some headset help
« on: 10:56 PM - 06/05/08 »
Has anyone figured out a way to use a usb headset to hear xb360 audio?  I bought a niiice pc usb headset (microsoft) and I want to be able to listen to my pc sound and xbox sound through this thing!  :-\

Pages: [1]