XIM Community

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - wicked96ta

Pages: [1]
1
General Discussion / Warface coming to Xbox One
« on: 10:12 PM - 06/29/18 »
Possible support for this? I had lots of fun with on PC but it was full of Chinese hackers. Comes out in September of this year.

https://youtu.be/qhOTKydFnnI

2
General Discussion / Sennheiser HD 650 and Xbox One X
« on: 04:12 PM - 12/13/17 »
I was wondering if those of you with more knowledge with audio equipment could help me out. I got the HD650's recently and all the sounds are extremely low. I was using an Astro mixamp 2013 with some TB's and the sound was loud. I hooked up the HD650's to the mixamp but my sounds are low. I'm guessing the amp isn't strong enough? I tried looking up info on this but nothing too helpful. Any and all advice is greatly appreciated.

3
As the title says, I can't copy any ballistic curve codes. I tried using my phone and it didn't work so I figured I'd try on my laptop in offline wired mode and nothing still.

Firmware: 20160405
Manager: 20160405

I tried going back to some of the older builds but it says I don't have access to it. Any help would be greatly appreciated.

4
Support / Mistake ordering
« on: 04:34 AM - 03/21/12 »
Hey guys, I just ordered a XIM3 for my brother in the states but I think I screwed up the city it goes to. I left the APO portion on instead of adding of the city. Will this cause an issue on the delivery? Everything else is correct though. The APO is still on because I got one sent to me here to Korea. I have the order number if you guys need it. Thank you very much.

5
Hey everyone, I have a question and hopefully someone here has an answer. I just purchased the adapter mentioned above to try to connect my headset to it but whenever I connect it, my Xbox turns off and will not start. This is while it's hooked up with the HDMI cable to my monitor. I tried it on 2 different Xbox's and it does the same thing. Any ideas why? I've read the instruction sheet that came with the adapter and even went online to see if I was doing something wrong but didn't find anyone with the same issue as me. Any help is greatly appreciated.

Here is a link to the adapter:
http://www.amazon.com/Xbox-360-HD-Analog-AV-Adaptor/dp/B004TEN2TO

6
Configurations and Requests / BFBC1
« on: 09:30 PM - 06/12/11 »
Hello everyone. I was wondering if anyone here has a good config for BFBC1. I tried using the search button but didn't find any configs, just people talking about the game. I used PhilAshio's config for BF1943 and am enjoying that one very much. But it does not work good for BFBC1. Any help is greatly appreciated, and I am so glad I ran across this site.

Pages: [1]