XIM Community

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Skymutt

Pages: [1]
1
Ok, long story short, I was in on the first shipment of DIY XIM2 RevB chips.  I built it, monkeyed around for a bit, then just kinda stopped.  It turned out I got really good at COD4 without it, so I just got used to controllers.

Now I'm back, and sick of people with aimbots and wallhacks kicking my @#$% in MW2. Don't get me wrong, I'm still pretty good, but not as good as I was before infection lobbys started making every kid with a paypal acct into a god.

Anyone wanna point me toward the best MW2 config?

Also, I watched the vids and Arcticpenguin99's just looks insanely impossible: one-shot no scope kills from the other side of the map, blind knife toss kills, etc.  In fact, at about 1:30 there's a scoped kill that you can see the round hit the wall about a foot behind the guy and he still dies...  Someone tell me, is that all XIM? Cuz it looks like aimbot @#$% to me.  If it's all Xim, I wanna get me some of that koolaid, if not I may play around a bit and then sell my XIM2.

All comments, questions, and suggestions are greatly appreciated.

-Mutt

2
XIM 2 Discussions / Finally found the time...
« on: 11:35 PM - 10/06/08 »
After having the thing for what feels like forever, I finally managed to get it assembled!
I took my time, threw in a couple drink breaks, etc, and it only took about 2 hours (I'm a perfectionist though, trimmed each wire perfectly, test fit a few times, etc.) I just finished the stress test, 5000 iterations and no errors. Just felt like celebrating.

The problem is that it's now time for me to hit the sack and I won't get to play with it till tomorrow after work :(  It's gonna be a loooooong 8 hours, that's for sure.

3
General Discussion / XIM2 DIY instructions available?
« on: 03:34 PM - 07/31/08 »
Just wondering if you guys would release the DIY kit instructions to us? I returned some junk to walmart with no receipt the other day and exchanged it for a 005 controller. I'd like to get the controller PCB's contacts prepped and maybe even solder in the 30awg leads so it's all ready when the preorder boards arrive.

4
General Discussion / Would anyone look down on me for...?
« on: 11:49 AM - 04/23/08 »
...begging for any kind of XIM2 update?   

With no updates since the 4th, the silence has been killing me!

5
General Discussion / Is it me, or are PMs not working?
« on: 09:28 AM - 03/14/08 »
I've sent a couple PMs lately, and gotten no replies.  I would think people are ignoring me, but there is nothing in the outbox either, so I don't even know if they've actually been sent/received.

Pages: [1]