1
Beta / Re: Steady Aim [ADVANCED USERS ONLY]
« on: 03:47 PM - 04/14/20 »
Sounds like SA3 best to try on warzone? Using xbox one s with day one controller. Any new data on warzone?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Welcome to the community. Here are the numbers reported by the community for past CoD games:
Assault Rifles: 250ms (Quickdraw: 150ms)
Submachine Guns: 200ms (Quickdraw: 100ms)
Light Machine Guns: 450ms (Quickdraw: 338ms)
Sniper Rifles: 400ms
Shotguns: 250ms
Handguns: 125ms
I think they changed the ADS times for IW. I say this because I primarily snipe and with the delay set to 400ms I don't get any aim lurching (that roads found and created the 2.4x method to fix). But if I lower it at all the lurching happens and its pretty noticeable. That makes me think that they raised the ADS time for sniper rifles and if you run quickdraw it brings it down to 400ms.
Just an observation I had.
I recommend using the firmware I posted at the top of my setup page. It has 'Progressive Delay' a much better alternative to regular Delay. It's also STv2.
Good luck.
Your enthusiasm is great, but everyone's a little different so don't count your chickens just yet.
Based off of what you described, both of these curves could and should be helpful. But the XIM was intended to be used without ballistics. Ballistics are here because of Anal gamers like us that want to fine tweak everything to our own liking. That being said, XIM can't account for aim assist. That's why these curves were made, for the most part. Some people though, really like sticky aim, so you never know.
And yes, I would suggest you leave aim assist [ON], some assist is a good thing for most people.