Messages

1

XIM APEX Discussions / Re: Beloader + Cronuszen + Xim Apex = Working!

« on: 07:22 AM - 01/20/22 »

Got the same problem i am using a ps5 controller tho instead of a ps4. Dont know why its not working need help

What problem?

2

XIM APEX Discussions / Re: Beloader + Cronuszen + Xim Apex = Working!

« on: 04:28 PM - 01/18/22 »

Could you send me a picture of your cables?  I meant if you provided electricity.

3

XIM APEX Discussions / Re: Beloader + Cronuszen + Xim Apex = Working!

« on: 05:58 AM - 01/18/22 »

4

XIM APEX Discussions / Re: Beloader + Cronuszen + Xim Apex = Working!

« on: 05:54 AM - 01/18/22 »

Ps4 speciality on cronuszen manager = Off

Have you powered up your hub?

5

XIM APEX Discussions / Re: Beloader + Cronuszen + Xim Apex = Working!

« on: 12:49 PM - 01/17/22 »

6

XIM APEX Discussions / Re: Beloader + Cronuszen + Xim Apex = Working!

« on: 12:15 PM - 01/17/22 »

I was able to get everything to work with 0 delay

7

XIM APEX Discussions / Re: Beloader + Cronuszen + Xim Apex = Working!

« on: 01:58 PM - 01/16/22 »

It also works with the Ps5 pad although it requires more power.  A 5v 3a charger is more than enough.  I have not physically connected anything to the ps5 I have the problem of the wasd keys.

8

XIM APEX Discussions / Beloader + Cronuszen + Xim Apex = Working!

« on: 11:14 AM - 01/16/22 »

Good evening, after a few days of trying I managed to get my SET to work: BELOADER + CRONUSZEN + XIM APEX.


 Connections:

 












 My hardware:
 - PS5 DIGITAL
 - BELOADER WITH LATEST FIRMWARE (WIFI)
 - CRONUSZEN WITH LATEST FIRMWARE AVAILABLE (OUTPUT PROTOCOL ON AUTO / PS4 SPECIALTY OFF)

 - XIM APEX WITH LATEST FIRMWARE AVAILABLE (1000HZ POLLING RATE)
 - POWER SUPPLY (FOR HUB XIM APEX) 5V 2A
 - POWER SUPPLY (FOR BELOADER) 5V 3A
 - DUALSHOCK V1 FOR XIM APEX
 - KEYBOARD FNATIC STREAK65
 - LOGITECH G502 HERO MOUSE (SET TO 25k DPI - 1000HZ POLLING RATE)
 - USB CABLES SUPPLIED WITH CRONUSZEN

 I state that if I connect Beloader + Xim Apex I do not find any anomalies, I can play without disconnections, I only have a little delay due to the use of WiFi, a problem that I think I will solve by connecting beloader to a LAN ETH> USB adapter, WASD works.
 If instead I connect the BELOADER + CRONUSZEN + XIM APEX I find (watch the video below) synchronization problems (I think) in the WASD keys, if I press the W key for example the first time it will work quietly, once I press W again, Xim records the pressure but does not carry out the command, same for the ASD keys.
 Is it possible to do anything to avoid this?  Is this a solvable problem?  Will any updates come out?

 Video:

https://youtu.be/oDxqwkfV6d0