XIM Community

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ikaros007

Pages: [1]
1
this config rocks but when i put sab = off mouse do some real strange turns

2
How i lowered it to 95? by adjustment the right vertical line? .....dident lower to 500hz, i just lowered my mouse sensitivity to 500dpi via synapse ..is it wrong ? it feels legit to me...

Go back up to 800DPI, much lower doesn't work well with XIM in my experience. Then to reduce sensitivity, as others have said, move the bottom (horizontal) slider all the way to the right, then use the vertical slider to reduce the steepness of the curve and reduce the sensitivity.



Note that the standard boost curve decreases the aim assist by quite a lot, so high smoothing works fine with it. I, like you, found 500 and linear too fast, so I had to use a reduction curve and reduce the top end to 82%. This made the aim assist way too strong and I had to lower the smoothing to 8 to get it to feel good.

thanks for the great settings you gave me ..I was apply them on apex legends ST and i can tell you is really op..
but on cod MW its another story for me this config(MJfames) dosent work well ......

3
MJfame i watch all the videos i read this topic 1000 times but i cant unterstand how you decrease mouse sensitivity via the balistic editor ...
the arrow when you set balistic curved ,is only turn at left values not right....

The last point on the right = 100 in the curve has to be lowered to for example 95. That way you reduce the mouse sensitivity :).

How i lowered it to 95? by adjustment the right vertical line? .....dident lower to 500hz, i just lowered my mouse sensitivity to 500dpi via synapse ..is it wrong ? it feels legit to me...

4
please corerct me if im wrong..

ADS Yaw Speed/ pitch speed :  5 left from the end .

ADS Turning Extra Yaw / ADS Turning Extra Pitch /ADS Turning Ramp-up Time/ADS Turning Ramp-up Delay : set it to max.

this is correct?

5
MJfame i watch all the videos i read this topic 1000 times but i cant unterstand how you decrease mouse sensitivity via the balistic editor ...
the arrow when you set balistic curved ,is only turn at left values not right....

Pages: [1]