XIM Community

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Kenaiinaugust

Pages: [1]
1
Game Support / Re: Destiny 1&2: Advanced Setups (20190801)
« on: 04:31 PM - 09/15/19 »
Ok, so it doesnít seem to be possible to downgrade my manager in my situation. Would anyone be kind enough to send me a thief RML  full CONFIG code for the latest firmware/manager?

2
Beta / Downgrade Manager on IOS. No access to Testflight
« on: 07:12 PM - 09/13/19 »
So i want to use an advanced config but it requires a downgraded firmware/manager. Then i can update the software to convert the config build to the current releases.

The problem I face is I only have Apple stuff. Firmware is no issue, But Testflight only opens to a blank page that says i don't have any beta's available and a code redeem button, so i can't downgrade in there. How can I downgrade my manager on IOS so I don't keep getting paste errors?

3
The problem i faced even with the awful GHub was my mouse was g-shifted. I changed it back and it worked.

You gotta map the buttons in the software, enable on board memory and if you're using GHub, you have to go into the settings menu and save the setup under a profile on your mouse.

4
Game Support / Re: Destiny 1&2: Advanced Setups (20190801)
« on: 10:04 PM - 09/12/19 »
Ugh... I canít figure out how to load these CONFIG codes into XIM manager. every time I attempt to paste, the button displays ďerrorĒ. Iím using iOS with the latest XIM manager to attempt that...  Is that a problem?
I just really wanna get this @#$% mouse dialed in!
Any help would be greatly appreciated.

Btw, please explain like you would a fool.

EDIT: also it may be important to note that when I attempt to d/l the beta manager through TestFlight, it says the developer isnít accepting new beta testers.

5
I have that button remapped and it works for me. Make sure you have turned on the on board memory.

Ps ghub is garbage so I uninstalled it and used the Logitech gaming software instead and it was much easier to remap it.

I keep reading that... Iíll try LGS instead of GHub. Thnx.
I have the on board turned on, but I also realized that it was in g-shift mode and I saved the profile  normal mode.

6
Just received my XIM Apex and peripherals and Iíve been configuring for hours. I canít get a button assigned on my g502. Iíve enabled on board in G-hub, Iíve assigned a letter (L) to the DPI shift button where the thumb sits. I want to make that my ADS button. What am I missing?

Pages: [1]