XIM Community

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - biscojoe

Pages: [1] 2 3 ... 32
1
I am a newbie and need a copy of Destiny 2 settings, I can’t set it up well myself

same  ;D

2
Anyone snipe w this config? Having inconsistent results when adsing, but shredding w ar’s and smgs

Oh trust me. It doesn’t get better with any other configs you’ll find. It’s just the way snipers behave in this game specifically. Just make sure you have you ADS activation delay set to the actual ADS time of the sniper you’re using as a start. (For example the ads time for the LW3-Tundra currently is 583ms with serpent grip.) In Cold War your bullet is not 100% accurate until about 1 frame AFTER you can see images in your scope. Anything before is considered a “hip-fire” therefore you’re at the mercy of in-game latency, input-delay, and last second AA bubbles issues. Get the ads value timing locked in, then mess around with your ads sensitivities, Smoothing and SA until you find something that “works”. But unfortunately too my knowledge there is no way to get that controller-like quick scope if that’s what you’re looking for, at least consistently. You might snap right onto 1 guy, and then your cross gets pushed away from where you had it on the next guy. At least in this game, to my knowledge, so far…lol

should we change our ADS activation delay on every gun we're using to what it says in the gun details? or is using 224 ideal for every gun (except for when you're sniping ofc, even though i never change it) just wondering cause i always use 224 hah..

btw i'm using 25.6K DPI 1,000Hz on mouse and 500Hz on XIM... Off sync with 7 smoothing on both HIP/ADS... HIP sens is 16.8 and ADS is 8.4... max ingame sens with standard/legacy for AA options, fov is 85

3

25,600 DPI Variants :)
(RML's AAA Curve #6 on HIP & ADS)

HIP (250Hz)
• Off Sensitivity: 8.40
• Default Sensitivity: 4.20
• Common Sensitivity: 2.10 <- Currently Using
• Slow Sensitivity: 1.05

ADS (250Hz)
• Off Sensitivity: 4.20
• Default Sensitivity: 2.10
• Common Sensitivity: 1.05 <- Currently Using
• Slow Sensitivity: 0.52

HIP (500Hz)
• Off: 16.80 (4 to 8 Smoothing)
• Default: 8.40
• Common: 4.20
• Slow: 2.10

ADS (500Hz)
• Off: 8.40 (4 to 8 Smoothing)
• Default: 4.20
• Common: 2.10
• Slow: 1.05

HIP (1,000Hz)
• Off: 33.6 (11 to 20 Smoothing)
• Default: 16.80
• Common: 8.40
• Slow: 4.20

ADS (1,000Hz)
• Off: 16.80 (11 to 20 Smoothing)
• Default: 8.40
• Common: 4.20
• Slow: 2.10

Ballistic Curve: (HIP & ADS)
Code: [Select]
>>> XIM APEX [AAA Curve #6] START COPY >>>
X5BC:gACBLIJYgyCD6ISwhhiG4IeoiHCJOIrci6SMbI00jfyOxJCkkWySNJL8k8SUjJVUl0iYEJjYmaCaaJswm/icwJ7wn7iggKFIohCi2KOgpGilMKcQpxCnEKcQpxCnECcQJxAnECcQ:X5BC
<<< XIM APEX END COPY <<<

RML's AAA Curves Thread
https://community.xim.tech/index.php?topic=80148.0

Code: [Select]
DPI Conversion;

> ( Current DPI × Current XIM Sensitivity ) = Total
> ( Total ÷ New DPI ) = New XIM Sensitivity

Dude, nice!

Very clean. A job well done. Thanks for the updated post. Tons of variation for everyone! If you don't have 25.6k dpi on your mouse, just convert your dpi ;)


4
for anyone wondering... after a buncha playing around with diff this diff that.. my go to's are def 15k mjfame variant and the 800dpi mjfame.

ez does it

5
Shared Configs / Re: Warzone Config | simple and effective
« on: 08:44 PM - 08/12/21 »
your discord doesn't work lol  8)

6
Shared Configs / Re: Warzone Config | simple and effective
« on: 01:59 PM - 08/12/21 »
your config has 244/244 on the activation deactivation delay and the post says 224/224... also what platform is this played on? PC? console?

7
Game Support / Re: Current Gen monitor suggestions.
« on: 04:37 PM - 08/09/21 »
By any chance anyone using the S2721DGF...

Have you calibrated it, any different  color/brightness/contrast/RGB gain/hue/etc etc adjustments on it? Game HDR vs Desktop or Off? Or just out of the box? I was curious if there was a way to make my Modern Warfare look a bit better, it seems kinda washed out as in it's too bright... should I maybe try not using dark stabilizer ?

8
1000Hz RR with Sync Off will have the least input lag.

Not that it matters as forcing the Xbox USB port to 1000Hz can cause mouse jitter, audio garbling and skipped frames. If that happens, try 500Hz instead.

Don’t get hung up on input lag. Consoles are expecting 125Hz input wirelessly and 250Hz max over USB. Use whatever feels best to you.

thanks for the info man

9
Hey Blamer

I really enjoy your settings and testing methods a lot, I'm going to give this one (250hz common) a try!

I was just wondering - when you were testing your configs (specifically this 250hz common) on MW/WZ, did you play around with different SAB values? Did they have a negative effect on this config in your opinion?

Yea dude, Blamer has put out some nice configs and taken the time to share with the community. Pretty shred.

On that note, you should definitely try the 10,000 DPI 500/500hz setup. I enjoy it a lot. Been using it lately and it's been great for me. Add a parachute aux to the config and you're good to go man. Pretty funny considering it's a vanilla setup on Common sync basically. no curves. no SAB. just .3 SA. I think I may play around with SAB values but for the time being, no change is required. Try it out for yourself if you haven't already.

10
This game looks so fun, I hope it doesn't rock a (U) behind it's name when the ST drops

11
Shared Configs / Re: MW/Warzone Advanced Setup (12/22/20)
« on: 11:43 AM - 08/06/21 »
Love the setup but I’m running xim at 1000hz too seems to suit me better.

Only problem I have is if I swipe then lift my mouse I keep turning in game until I put my mouse back down, any ideas?

Cheers

That's odd, idk lol. sounds like LOD (Lift off distance) something that happens on a PC... I use this config as my go-to primarily and love it, tried changing the xim PR to 1k and it's actually pretty noiceee!

12
This 25.6K 250hz common sync config shreds!!!!!!!!!!!!


13
Game Support / Re: Current Gen monitor suggestions.
« on: 06:13 AM - 08/04/21 »
It almost feels unfair playing against PS players on cross platform games right now. They really can't compete against 1440p 120hz. Couple that with XIM performance on Series X and every lobby feels like you're on virtual Prednisone!

What competitive games are you playing 1440p 120hz? I've been trying to work out what games in series x offer this but they all seem to downscale the resolution to 1080p. Cold war didn't go so low... it's about 1200p, but definitely worse than 1440p.

I don't know what you're talking about? All my games I play... I play at 1440p 120hz on my Xbox Series X.... even if a game doesn't support 120 fps... your monitor will still display 120hz and it will feel smooth? MW & CW are my prime 2 games and they run flawlessly

I didn't say anything about how they run... and I don't know about MW because I don't play it any more... but CW does not run at 1440p 120hz and that's a fact. It runs somewhere around the 1200p mark when you play it at 120fps, which is still better than most games that downscale to 1080p at 120hz. And to my knowledge 120hz is not the same as 120fps. I play apex legends at 120hz but it still only gives me 60 fps, at a much reduced resolution to when I play on my 4k 60hz monitor... and it's certainly no smoother because the the console is still only putting out 60fps.

I still don't know what you're talking about.... a game that is outputting 60fps max but is running at a refresh rate of 120hz/144hz etc etc will show smooth gameplay. I run Cold War at 1440p... and i'm running it on 120hz... if my frames aren't 120fps.. i don't care... refresh rate is more important.... I understand frames and refresh rate are 2 different things. I am a PC Gamer who moved to console gaming. I know what I am talking about for the most part. So, I'm a bit confused. If you're saying CW doesn't "run at 120hz" ... that means that your monitor doesn't support 120hz? Are you confusing that with frames per second? Like I said, if a game isn't running 120 fps... but is running on 120hz, you're still provided with smooth gameplay. That's like saying "my frames are about 150-200 in CS:GO on PC but my refresh rate is 144hz"... and even so, it results in smooth gameplay.

14
Game Support / Re: Current Gen monitor suggestions.
« on: 03:25 AM - 08/04/21 »
It almost feels unfair playing against PS players on cross platform games right now. They really can't compete against 1440p 120hz. Couple that with XIM performance on Series X and every lobby feels like you're on virtual Prednisone!

What competitive games are you playing 1440p 120hz? I've been trying to work out what games in series x offer this but they all seem to downscale the resolution to 1080p. Cold war didn't go so low... it's about 1200p, but definitely worse than 1440p.

I don't know what you're talking about? All my games I play... I play at 1440p 120hz on my Xbox Series X.... even if a game doesn't support 120 fps... your monitor will still display 120hz and it will feel smooth? MW & CW are my prime 2 games and they run flawlessly

15
All your configs shred bro. Some lower DPI configs would always be a score!

Pages: [1] 2 3 ... 32
Admin